I have this old relic 95 Lagunmatic 3516 that I have been trying to DNC for about 3 years. The Delta 40M controller is supposed to be able to do this. I have tried every cable configuration, every setting, you name it. I use DNC4U and it has worked on all my other mills. I get all green lights but the pc and the controller just won't talk. I had a tech in here to change a spindle position sensor. This guy was VERY good at what he did. He said he had never seen anyone get that controller to drip. I run from the floppy drive all the time. But I'm limited to 1.2 or so megs. Is there any way to created a virtual A drive on a pc that I could cable into the machine? I could run huge programs that way.

Phoodieman

Similar Threads: